Brand: Feiyu Tech
Item No.: A2000
Weight: 1111.5g (not inclusive of battery, camera, lens and so forth) Compatible Cameras
Canon 5D Mark III (with standard lens), SONY A7RII / ILCE-7R / ILCE-5100, Panasonic LUMIX GH4/GH5, SONY NEX-5N/NEX-7 and other cameras of N-series,and other cameras with similar dimensions.
Payload : 250--2500g (Including the accessories of batteries, lens and ect. The upgraded payload (2500gram) is applied for the new firmware a2000_V1.0.9.24 or above) Tilting Angle: 360° (Unlimited)
Rolling Angle: 360° (Unlimited)
Panning Angle: 360° (Unlimited)
Tilting Increments: 2°/s ~ 75°/s
Panning Increments: 3°/s ~ 150°/s Battery
Battery model: 18650, 2200mAh, 3.7V. (one positive side upward and the other negative side upward)
Battery could be charged from external power sources by Micro USB port (It is fully charged when the LED changes from solid red to solid blue), or charged by smart charger (LED in solid red indicates the battery is charging, LED in solid blue indicates battery is fully charged).
Usage time About 12 Hours. Installation
Camera could be placed on the left or right side by moving tilt axis to the left or right. When moving the lens forward, we suggest placing the camera on the left side so that you can use interfaces for HDMI, shutter control, headphone, microphone and so on. Charging time
≥5 hours, recommending using smart charger for charging the battery(Do not use quick charger), 5V/1A input. Balance Way
Moving quick plate back and forth to balance tilt axis in horizontal direction.
Sliding the arms of three axis to balance the center of gravity of camera, and then tighten the lock screws for three axis. Adjusting Motor Strength
Automatic identification algorithm to detect weights of different cameras and produce right motor strength to match with them , so that the gimbal will automatically be in the best performance without adjusting the motor strength. Extended Interface
There are three 1/4 inch screw holes for single handheld version of a2000 (one on the panning axis, one on the socket connector, and one on the bottom of the handle)
There are nine 1/4 inch thread holes could be found on a2000 with dual grip handle kit: four in the middle part of foldable arm, four on the two handles, the other one is on the socket connector. | 
Ask a question
